Shower Panels design – the beauty of simplicity and functionality

Comes Complete Ready to Install with Easy Installation Instructions. All Shower Panels design is tested Before Shipping. Ready to pamper yourself yet? If so, installing a Shower Panel is no more difficult than replacing your pre-existing shower arrangement with a new one. If you’re starting fresh with no existing shower, consult a plumbing expert prior to plugging one into your shower wall.

Preparing for installation

Install ½-inch IPS nipples for the hot and cold water supplies. The nipples should extend ? of an inch beyond the wall. The hot water supply is on the left, and the cold on the right. Install the wall surface material. Ensure the wall is watertight before installing the panel by applying a waterproof sealant, such as Teflon tape or plumber’s putty.

Installation

Install the elbows included with the panel and point them downwards. The elbow should extend no more than 1 ¼ inches from the surface of the wall. With a helper holding the panel in place, mark the positions of the screw holes and drill the holes with a 6 mm bit suitable for the wall surface.

Drop anchor

Install the anchors, and seal the wall with the waterproof sealant. While holding the panel against the wall, install the provided gray plastic insert and the top screw into the anchor.

Make your connections

Install the center and bottom screws and washers. Connect the supply hoses to the hot and cold supply elbows and the inlet ports on the valve. Turn the water on at the main. Push the diverter stem up to turn the water on to the panel, and check the connections for leaks. When the connections are watertight, push the diverter stem down to cut the water.

Just a few easy installments

Install the side seals on the front cover, trim off any excess and push the front cover into place. Install the diverter sleeve. Make sure the indexing mark on the thermostatic mixer sleeve is at the 12 o’clock position. Install the thermostatic mixer handle, and tighten the handle screw with a flat-head screwdriver.

To install the diverter handle, tighten the set screw with a 4 mm Allen wrench. Place a black rubber washer in one end of the hand shower hose, and fasten the hose to the hand shower outlet port. Place the screen washer in the other end of the hose, and screw this end of the hose to the hand shower. Place the hand shower in the holder.

Adjust the Slider

You can make the slider easier or harder to move by using a 2 ½ mm Allen wrench. Turn the water on to the hand shower, and turn the thermostatic mixer handle until the output water measures 100 degrees on a thermometer, then cut the water.

Turning the handle clockwise makes the water cooler, counter-clockwise makes the water warmer. Loosen the thermostatic mixer handle screw, and remove the handle. Replace the handle so that the safety stop override button is at the 12 o’clock position.

You can continue your read with wall mount bathroom shower panel system, Exposed shower set reviews.

Simple Shower Panel Installation Instruction